Posts Tagged ‘28mm’

Command & Conquer

October 3, 2012

I wrapped up my British modern forces with this British Infantry Platoon Command from the Assault Group and it’s a fitting end.  This pack contains two officers waving their arm around, a field radio man and a soldier with a 2 inch mortar.

When I started painting the new British MTP camo I was quite hesitant but happy with the eventual results. As I’ve done more it’s become a speedy freehanded joy although it has evolved into getting larger in pattern and lighter in overall shade. Hopefully these will mix well and produce the variations you see across a number of troops in the field.

A small hole was drilled into the top of the radio pack for a small aerial to be added using a thin pin with the head snipped off. It might not be that accurate as I’ve seen some radios which have some folding type of antenna and others which seem to thicken towards the top, almost like a silencer on a gun barrel. It suits my needs of course, and for added realism it’s likely to stop working at the most inconvenient time.

It’s very likely for these pieces to become primary targets for snipers based on the old idea that anyone waving their arms around must be an officer and should be shot first.

The 2 inch mortar is an unusual piece of kit as it’s been used by the British Army in one form or another for almost one hundred years. It started life as the 2 inch Medium Mortar in 1915, only to be dropped two years later.  By 1937 the over-titled Ordnance SBML 2 inch mortar was developed and saw service for decades until the late 1980s, being replaced by the metric L9A1 51mm Light Mortar or 2.02 inch.  Which is what is used today and this chap has. Watch out Terry Taliban.

Hee Hawfully Good Models

October 3, 2012

This sublime Donkey Mill is another one of those timeless pieces which would fit a wide period of games, ancient to modern and be a great addition to them all. I’d seen the Architects of War Middle East range some time ago and always wanted to see it up close before parting with any shekels. I found this piece at Red Knight when they still had a shop and jumped on it immediately. With my upcoming Jihadistan game at a soon to happen show I finally pulled this out of the to-do pile.

The pack contains four pieces, the mill and ground as a single pre-coloured in brown resin piece, the millstone, the wood and the donkey all in pewter. As with most simple kits it’s also a little tricky. The millstone and the wooden upright have to be straight on the vertical while the horizontal beam has to meet the donkey’s harness properly. A tiny bit of tweaking was needed on the beam to get this right and i found the easiest way to assemble once painted was to hold it all in place and with my third hand glue the donkey into place first.

Corn was what I wanted being ground. So I gingerly picked out two shades of yellow from mixed flock packs with the agility of a diamond buyer with a date with Kiera Knightly. This was glued onto the mill and into the sacks before assembly. To harden it up I doped it with superglue, as it dried the two-tone yellows went dull brown, well two-tone brown. So had to be dry brushed with yellow to brings it back to life.

It was fun to paint, I imagine some might think the donkey is too small but foreign ones typically aren’t as healthy no9r as big as the seaside donkeys we see most offen. Can’t wait to get another piece from these folk.

Versa Tile

October 3, 2012

A big thanks to my Dad-in-law Bob for spotting these and many other Wilko own-brand floor tiles. There’s a fair few which are suitable for the wargames table, follow the Wilko link to see them, including various flagstones in both grey and sandstone. The pack I got will be used for roads, and just in time because I need plenty of them  for an upcoming game, one pack cut in half will give me over twelve foot of roads, even more if I was using a s cale smaller than 28mm. Just £5 a pack.

I’ve gone and taken photos of all of the ones which I thought were useful. The lightings not very good but you’ll get an idea. The texture is more printed than actual but there is a slight texture to them. Each photo is approximately six inches wide.

A rugged stone effect.

Mixed flagstone or crazy paving.

Sandstone flagstones.

Granite flagstones.

A sandy texture, roads perhaps?

Not a Tankless Task

September 6, 2012

A great weight has been lifted off the shoulders of the workers at Slug Industries seeing as we’ve finally got our latest, and hopefully greatest, model finished. Not a simple one this, with around forty hours on the build alone, seperate moulds for components, and the hot weather mucking up the paintjob on the first cast, but only after full highlighting. In other words a bit of a pain.

Here’s the first paintjob shortly before a lot of the surfaces simply started to crack. A few attempts at repair later and other cracks and flakes appeared. Casting another and painting that proved to be quicker.

The rear door which shows the riveting quite well.

The armoured radiator, which looks flat although it’s made of semi circular tubing, and the Dambuster style headlights. The idea being that they’re adjustable, so you could set a rang to them and when the merged lights lit up a target it’s at the predeterminde range. Probably worth a +1 on any dice roll – if it’s at night.

The first wheel layout. Ending up putting two extra pairs in after Orkdung over at VBCF quite rightly pointed out how it looked under powered. Figure gives a sense of scale.

 

Die Nacht der Toten

September 2, 2012

The boy Slug has a slowly evolving nazi zombie project inspired, in part, by the Call of Duty game which features the opportunity to shoot Nazi zombies. These figures are part of West Wind Productions Secrets of the Third Reich which we picked up a couple of Salutes ago. Rather uphappily I didn’t enjoy painting these at all. The detail seems a little limited, even confused. I have a sneaking suspicion this might be why these were the ones I was asked to paints.

The bases are the 30mm DS Ruined Flagstone set from Fenris Games, and those I enjoyed working on more than the figures. Slug set the figures on the bases and rather well I think, I really liked the one with a stream trickling through it, and the boy set the figure firmly standing in it.

All-in-all an odd experience. usually I strive to paint up to the sculpt but on these the piece which demanded justice was the base…

Even more Bazaar

September 2, 2012

Filling out the Jihadistan project gave me the chance to paint these rather brilliant Eureka miniatures‘ middle eastern civilians. There’s also a couple of stalls but I haven’t quiet figured out the best way to base those so they can wait.  It’s easy to assume how simple figures are simple to sculpt, and the burqa clad ladies might ecourage that train of thought.

However I already have a couple of burqa wearers and they’re simple figures simply done whereas these have been much better made. Each figure has a distinct attitude in it’s carving making them look more like a moment frozen in time.

They’re also rather timeless, with the exception of the woman with carrier bags, so could fit in an ancient scenario right up to the modern day. Although I wouldn’t buy anything from the traders I’ll be knocking on Eurekas door again.

Rubbish Grass

August 22, 2012

These are a few markers for general rubbish and grass tufts which we also use for marking IEDs.  The smaller ones are either Skale Scenics field grass or small scraps of metal folded and partially painted, The larger ones are chopped gas cannisters from the ever wonderful Fenris.  They’re all based on Fenris laser-cut ply bases. In game they’ve proved very interesting to use. In the first game we used them Daring Dan managed to set one off by driving over it in his very first move, this set a tone of wariness which has only worn off slightly as the majority of them are nothing but markers for grass or rubbish.

Troops Out… for the lads

August 20, 2012

It’s been a productive week on the Jihadistan front, bolstering the good guys with quite a selection of manufacturers and starting with this HMG from Brooks Miniatures. A very sweet support team which I don’t think my photography does justice to.

Again I’ve mounted them on a 40mm Fenris Games laser-cut ply base with various stones and tufts.

The Assault Group figures have become my favourite range for Modern Brits with a wide range even if I only use the helmeted ones. Four more have joined my ranks.

This is their prone pack with a SAW, an HMG, a bog standard SA80/L85 and a very neat sniper.

These have been painted but not based (awaiting bases) but you get the idea.

These will be finished off with the usual stones, sand and tufts.

blahHere’s the Empress Javelin Team which I’ve had unpainted for too long and it’s a handy addition to the forces.

Sadly these chaps come without weapons so I’ve added a couple of Hasslefree guns. Otherwise I’d worry about their personal safety.

The spare Javelin is a nice touch. This team comes with two other figures…

…this chap with a shotgun and a slung SA80 and another sniper. There’s something about snipers which I adore. I have far too many for a proper OoB but so what? They’re fun.

Finally a pack of Brooks Miniatures via Old Glory UK. I wanted a few more plain and simple squaddies with just SA80s to fill out the sections and these suit perfectly. I’ve painted these all in the new MTP camo, I’m not sure how accurate I’m doing it but it looks right to me and I’ve got it down to quite a rapid paint technique. Missing the big military shows over the last couple of years I’ve not had a good look at it, that’s my excuse and I’m sticking to it.

Here’s a comparison shot of individual figures, TAG, Empress, Brooks, LAM German Marine, Eureka German Bundeswehr.

And one of support teams; Empress, Brooks and TAG.

Boiler Tank

August 16, 2012

I’ve had an eye on the Tobsen77 models for a while now, thinking how a good few pieces were well suited to VBCW, but wary of the postal involved. Luckily I’ve been doing some casting for Tobi and managed to wrangle the One Man Army model above. Knowing I was using it for VBCW and being a bit of an engel he not only supplied it with the futuristic gun which is part of the kit he also made me a more suitable gun out of plasti-tube.

.I left the small spotlight off, and added the vintage car bumper, but the best part was how fast it was to do. Assembled and painted in a leaf pattern over one single short evening.  I really like how it looks as if it could have been a conversion of a water boiler.

A cracking little kit and great fun to work on. I’m tempted to have a few more as they work well as a Wooster Dalek declaring “What Ho!” and “I Say!” at the enemy.

Crouchie’s Workbench

July 18, 2012

En route to Dover model shop  the other day I pooped in to see Uncle Crouchie to deliver some resin cats to him and got the chance to see what everyone’s gaming Uncle had on his workbench, well his dining table.

First off this delightful light tank whose name I’ve forgotten. He did tell me but my knowledge isn’t as broad as his especially when it comes to the obscure which he builds a lot of to our delight.

Hopefully this is due for production, but we’ll have to wait and see.

This charmer is an early WW2 Belgian motor trike. Crouchie tracked down a couple of photos during an exhaustive search and from those he started this. The motorcycle is an adaption of his combination for the Belgians.

The bad news is how this isn’t for production, it’s just for his own use. A shame not least beacuse I imagine the VBCW crowd would snap this up.